Home    Zenders & Ontvangers   Graupner   Telemetrie  General Air Module 2-6S, Vario GRAUPNER 33611 Pakket
General Air Module 2-6S, Vario GRAUPNER 33611 Pakket

General Air Module 2-6S, Vario GRAUPNER 33611 Pakket




78.99

€ 74.90


Op voorraad


Artikelcode: 33611

General Air Module 2-6S, Vario GRAUPNER 33611  Pakket


  • Productinformatie

Description:
General sensor for Graupner HoTT receiver and models with internal combustion or electric motor.

Functions:
  • Vario with altitude signals plus climb and drop signals as well as additional warning thresholds for min. altitude, max. altitude, climb, and drop speeds in two stages
  • Altitude display (- 500 ' + 3000 m) and storage of min. and max. altitude
  • 2x temperature and voltage measurements with warning thresholds for min. and max. voltage and min. and max. temperature
  • Individual measurement with warning threshold for min. voltage
  • Voltage, current, and capacity measurement with warning threshold for min. and max. voltage, max. capacity, and max. current
  • Current limiting programmable
  • Messurment of the current with shunt resistors 2x 1 mOhm parallel = 0.5 mOhm
  • Rpm measurement and warning threshold for min. and max. rpms
  • Fuel measurement with warning threshold in 25% steps
  • Warning time can be set to: OFF, 5, 10, 15, 20, 25, 30 seconds, always
  • Warning repeat time can be set to: always, 1, 2, 3, 4, 5 minutes, once

Important Note when using the modules 33600, 33601, 33610, 33611 and 33620:
Do not carry out any programming work on the sensors while the model is flying, otherwise there is a real risk that your model will fly out of control while you are not concentrating on it!
If your model is fitted with two or more receivers, it is absolutely essential that you do not carry out programming work during a flight,
as this can alter the settings in the receivers to which no telemetry equipment is connected; in the worst case this could result in the model crashing!
For this reason always carry out programming on the ground, and check that only the receiver with connected sensor is powered on.

Connections and Technical data Vario:
2x temperature selectively 0 to 120°C or200°C and voltage measurement up to 60 V DC
1x rotational speed measurement up to 100,000 rpm with a two-blade propeller
1x speed controller/servo input, 1x rotational speed regulation input, 1x speed controller/servo output for rotational speed regulation
1x current and voltage and capacity measurement up to 40 A (pulse 1 s: 60 A) and up to 30 V
1x single cell monitoring for 2 - 6S lithium batteries (LiPo, LiIo, LiFe)
1x receiver power supply input and output
1x telemetry connection for receiver
1x fuel sensor 0%/25%/50%/75%/100%
Altitude measurement: -500 m ... +3000 m
Resolution: 0.1m
Vario sensitivity: 0.5 m/3 s, 1 m/3 s, 0.5 m/s, 1 m/1 s, 3 m/s programmable by tone
Average calculation: 4 - 20measurements programmable per measurement value
Specification
Dimensions (LxWxH): 41 (48) x 44 (56) x 16 mm
Operating voltage : 3,6 ... 8,4 V


Specification
All-up weight, approx.: 31 g
Dimensions (LxWxH): 41 (48) x 44 (56) x 16 mm
Operating voltage : 3,6 ... 8,4 V


Example: Data evaluation with the HoTT Manager